Click images for larger view

Screw 2

Extended Waste Ink Tanks prevents the waste pads inside the printer from filling up when changing inks.

Take your time to read these instructions before proceeding with installation. If you have questions before starting contact technical support service with this contact form.

Screw 3

Screw 4

To remove the cover from the printer unscrew the four(4) screws that hold the top onto the base as shown in the pictures. 

Two(2) screws at the front and two(2) screws at the back has to be removed.

Paper Thickness Lever

Remove the cover now

The paper-thickness lever is located at the top right of the printer. Adjust the paper-thickness lever in the middle before removing the cover.

Remove the cover now. 

Release the white lever

Move the Carriage

Release the white lever at the bottom left side of the cartridge carriage, which allows you to freely move the cartridge carriage to the left, away from the docking station.

Use a good light force, two types of pliers because the working space is very small and the pump tubing, where you need to attach an additional length of tubing, is no more then 1 Inch long.

Remove the side tab

Connect the tubing

Remove the Side tab.

Attach a length of tubing, long enough to have the end outside the printer, to the tube from the pump.

Finished!

Once you are done;

• Place the white side cap back.
• Move the carriage back home to the docking station.
• Doublecheck the paper-thickness lever is in the mid-position
• Replace the cover to the printer and you are all set.
  

If operating the printer, unscrew the bottle cap a little bit or, as I prefer, drill a little hole in the bottle cap to allow trapped air to escape.